Raspberry pi camera Board - Yosnalab

Raspberry pi camera Board

Raspberry pi camera Board attaches to Raspberry Pi by way of one of the two small sockets on the board upper surface. This interface uses the dedicated CSI interface, which was designed especially for interfacing to cameras. The CSI bus is capable of extremely high data rates, and it exclusively carries pixel data. The camera is connected to the BCM2835 processor on the Pi via the CSI bus, a higher bandwidth link which carries pixel data from the camera back to the processor. The camera is connected to the BCM2835 processor on the Pi via the CSI bus, a higher bandwidth link which carries pixel data from the camera back to the processor.

TECHNICAL DETAILS

  • Small board size: 25mm x 20mm x 9mm.
  • A 5MP (2592×1944 pixels) Omni vision 5647 sensor in a fixed focus module.
  • Support 1080p30, 720p60 and 640x480p60/90 video record.
  •  Current sense resistor : 0.1 ohm 1% 2W.
  •  Target voltage : Up to +60V.
  • Range : Up to  2.7V to 60V.
  • Low Quiescent current (60µA type).
  • Input clock Frequency : Up to 6 - 27MHz.